No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


CLI-based Configuration Guide - Reliability

AR100, AR120, AR150, AR160, AR200, AR1200, AR2200, AR3200, and AR3600 V200R010

This document provides guidance for configuring reliability services, including interface backup, BFD, VRRP, and EFM.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Interface Backup in Load Balancing Mode

Interface Backup in Load Balancing Mode

As shown in Figure 2-4, HostA communicates with RouterB through GE2/0/0 on RouterA. To prevent data loss caused by insufficient bandwidth of GE2/0/0, interface backup in load balancing mode is configured on RouterA. When the traffic volume on GE2/0/0 exceeds the configured upper threshold, a backup interface with the highest priority is used to load balance services. This improves reliability of data transmission.

Figure 2-4  Interface backup in load balancing mode

Updated: 2019-08-12

Document ID: EDOC1100034076

Views: 59997

Downloads: 107

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next