Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuration Examples for VRRP
- Example for Configuring a VRRP Group in Active/Standby Mode
- Example for Configuring a VRRP Group in Multi-gateway Load Balancing Mode
- Example for Configuring Association Between VRRP and BFD to Implement a Rapid Active/Standby Switchover
- Example for Configuring Association Between VRRP and the Interface
Status
- Example for Configuring Association Between VRRP and BFD to
Monitor the Uplink Status
- Example for Configuring Association Between VRRP and NQA to
Monitor the Uplink Status
- Example for Configuring Association Between VRRP and Routing
to Monitor the Uplink Status
- Example for Configuring VRRP on a Dot1q Termination Sub-interface
- Example for Configuring VRRP on a QinQ Termination Sub-interface
- Example for Configuring a VRRP6 Group in Active/Standby Mode
- Example for Configuring a VRRP6 Group in Load Balancing Mode
- Example for Configuring VRRP IPv6 Association
In this example, a VRRP IPv6 backup group is associated with a BFD session. This association allows the backup device to take over traffic if an interface or a link on the master device goes Down. - Using Python Scripts to Implement Interworking When VRRP Nodes Fail
Previous
