No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - Reliability

AR100, AR120, AR150, AR160, AR200, AR1200, AR2200, AR3200, and AR3600 V200R010

This document provides guidance for configuring reliability services, including interface backup, BFD, VRRP, and EFM.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Overview of CFM

Overview of CFM

CFM defines Operation, Administration, and Maintenance (OAM) functions and provides link connectivity detection.

Easy-to-use Ethernet techniques support good bandwidth extensibility on low-cost hardware. With these advantages, Ethernet services and structures are the first choice for many enterprise networks, Metropolitan Area Networks (MANs), and wide area network (WANs). The increasing popularity of Ethernet applications promotes the use of Ethernet OAM functions because traditional Ethernet has poor maintainability and operability.

Hierarchical Ethernet OAM needs to be provided based on the network architecture, as shown in Figure 9-1.

Figure 9-1  Networking of Ethernet OAM

  • IEEE 802.3ah, also known as Ethernet in the First Mile (EFM), is a link-level OAM mechanism that defines the specifications of the Ethernet physical layer and OAM used for user access. It provides link connectivity detection, link fault monitoring, remote fault notification, and remote loopback for a link between two directly connected devices.

  • IEEE 802.1ag, also known as Connectivity Fault Management (CFM), defines OAM functions, including Continuity Check (CC), Loopback (LB), and Linktrace (LT). CFM is network-level OAM and is applicable to large-scale end-to-end networking.

  • Y.1731 is an OAM protocol defined by the Telecommunication Standardization Sector of the International Telecommunication Union (ITU-T). It covers items defined in IEEE 802.1ag and provides additional OAM messages for fault management and performance monitoring. Fault management includes alarm indication signal (AIS), remote defect indication (RDI), locked signal (LCK), test signal, automatic protection switching (APS), maintenance communication channel (MCC), experimental (EXP) OAM, and vendor specific (VSP) OAM. Performance monitoring includes frame loss measurement (LM) and delay measurement (DM).

Translation
Download
Updated: 2019-08-12

Document ID: EDOC1100034076

Views: 57017

Downloads: 107

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next