No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - Reliability

AR100, AR120, AR150, AR160, AR200, AR1200, AR2200, AR3200, and AR3600 V200R010

This document provides guidance for configuring reliability services, including interface backup, BFD, VRRP, and EFM.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Information on the Master Device Fails to Be Backed up to the Backup Device

Information on the Master Device Fails to Be Backed up to the Backup Device

Fault Description

After HSB is configured, the HSB channel cannot be established and information on the master device fails to be backed up to the backup device.

The possible causes are:
  • The parameter settings on active and standby channels are different.
  • The source IP addresses and port numbers at the local and remote ends are different.
  • The retransmission count and interval of HSB packets are different on the two devices.

Procedure

  1. Run the display hsb-service service-index command in any view to check whether HSB channel parameters are the same on the local and remote devices.

    • If the source IP addresses and port numbers at the local and remote ends are different, run the service-ip-port local-ip local-ip-address peer-ip peer-ip-address local-data-port local-port peer-data-port peer-port command to set them consistent.
    • If the retransmission count and interval of HSB packets are different on the two devices, run the service-keep-alive detect retransmit retransmit-times interval interval-value command to set the same values at both ends.

Translation
Download
Updated: 2019-08-12

Document ID: EDOC1100034076

Views: 57789

Downloads: 107

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next