No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - Security

AR100, AR120, AR150, AR160, AR200, AR1200, AR2200, AR3200, and AR3600 V200R010

This document provides the basic concepts, configuration procedures, and configuration examples in different application scenarios of the network management feature supported by the device.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Using an ACL to Filter OSPF Routes

Using an ACL to Filter OSPF Routes

An ACL can be applied to various dynamic routing protocols to filter advertised and received routes.

In Figure 5-9, the network runs the Open Shortest Path First (OSPF) protocol. RouterA receives routes from the Internet and advertises the routes to the OSPF network. The OSPF network is allowed to access only three network segments: 172.16.17.0/24, 172.16.18.0/24, and 172.16.19.0/24. The network connected to RouterC is allowed to access only the network segment 172.16.18.0/24.

To meet the preceding requirements, an ACL and a routing policy are configured on RouterA. This routing policy permits RouterA to advertise only the routes on network segments 172.16.17.0/24, 172.16.18.0/24, and 172.16.19.0/24 to RouterB, so that the OSPF network can access only these three network segments. An ACL and a routing policy are also configured on RouterC. The routing policy permits RouterC to receive only the route 172.16.18.0/24, so that the network connected to RouterC can access only the network segment 172.16.18.0/24.

Figure 5-9  Using an ACL to filter OSPF routes

Translation
Download
Updated: 2019-08-07

Document ID: EDOC1100034077

Views: 137241

Downloads: 244

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next