No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - Security

AR100, AR120, AR150, AR160, AR200, AR1200, AR2200, AR3200, and AR3600 V200R010

This document provides the basic concepts, configuration procedures, and configuration examples in different application scenarios of the network management feature supported by the device.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Broadcast Traffic Suppression Does Not Take Effect

Broadcast Traffic Suppression Does Not Take Effect

Fault Description

After broadcast traffic suppression is configured on an interface, a broadcast storm caused by broadcast packets still occurs and service traffic is interrupted.

Common Causes

This fault is commonly caused by one of the following:
  • Broadcast suppression is not configured on interfaces, or the broadcast suppression threshold is set too high.
  • Broadcast packets are not discarded on the inbound interface.
NOTE:
  • Saving the results of each troubleshooting step is recommended. If your troubleshooting fails to correct the fault, you will have a record of your actions to provide technical support personnel.
  • Troubleshooting for multicast and unknown unicast traffic suppression is similar to that for broadcast traffic suppression.

Procedure

  1. Check that traffic suppression is correctly configured on the related interface.

    Run the display flow-suppression interface interface-type interface-number command in the user view to check whether the values of rate mode and set rate value in the broadcast field are proper.

    • If these values are appropriate, go to step 2.

  2. Check whether broadcast packets are being discarded in the inbound direction of the interface.

    Use the following methods to check whether broadcast packets are being discarded in the inbound direction of the interface:

    • Run the display interface interface-type interface-number command in the user view to check whether the value of Input bandwidth utilization changes greatly after traffic suppression is configured. Normally, after traffic suppression is configured, bandwidth occupation on an interface decreases if the interface is discarding excess packets. If the value of Input bandwidth utilization does not change or changes verify little, go to step 3.

    • Add another interface (interface B) to the same VLAN as the interface (interface A) that is configured with traffic suppression. Then check whether the volume of the outgoing traffic on interface B is the same as the volume of the traffic on interface A. If they are different, packets are not discarded in the inbound direction of interface A. Go to step 3.

  3. Collect the following information and contact technical support personnel.

    • Results of the preceding troubleshooting procedure
    • Configuration file, logs, and alarms of the member switch

Translation
Download
Updated: 2019-05-20

Document ID: EDOC1100034077

Views: 112026

Downloads: 204

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next