No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - Security

AR100, AR120, AR150, AR160, AR200, AR1200, AR2200, AR3200, and AR3600 V200R010

This document provides the basic concepts, configuration procedures, and configuration examples in different application scenarios of the network management feature supported by the device.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
IPSG Does Not Take Effect When Dynamic IP Address Allocation Is Used Because DHCP Snooping Is Not Configured

IPSG Does Not Take Effect When Dynamic IP Address Allocation Is Used Because DHCP Snooping Is Not Configured

Fault Description

Hosts can obtain IP addresses from the DHCP server, and the IPSG function is enabled; however, IPSG does not take effect.

Procedure

  1. Check whether the DHCP snooping binding table exists.

    When hosts obtain IP addresses through DHCP, IPSG checks packets received by interfaces based on the DHCP snooping dynamic binding table. The device automatically generates DHCP snooping binding entries for online hosts only after the DHCP snooping function is enabled.

  2. Run the display dhcp snooping user-bind { { interface interface-type interface-number | ip-address ip-address | mac-address mac-address | vlan vlan-id }* | all } command to view DHCP snooping binding entries.

    If no dynamic binding entry exists, configure DHCP snooping according to Configuring IPSG Based on a Dynamic Binding Table. The major configuration steps are as follows:

    1. Enable DHCP snooping globally.
    2. Enable DHCP snooping on an interface or in a VLAN.
    3. Configure the trusted interface.

    After DHCP snooping is configured, the device generates DHCP snooping entries for the hosts when the hosts go online again. Then IPSG takes effect. If you enable IPSG before the device generates DHCP snooping dynamic binding entries, the device rejects all IP packets except DHCP Request packets. In this situation, communication service on the hosts is affected. Therefore, before enabling the IPSG function, configure the DHCP snooping function to enable the device to generate dynamic binding entries.

Translation
Download
Updated: 2019-05-20

Document ID: EDOC1100034077

Views: 112083

Downloads: 204

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next