No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


CLI-based Configuration Guide - Security

AR100, AR120, AR150, AR160, AR200, AR1200, AR2200, AR3200, and AR3600 V200R010

This document provides the basic concepts, configuration procedures, and configuration examples in different application scenarios of the network management feature supported by the device.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Defense Against Packet Fragment Attacks

Configuring Defense Against Packet Fragment Attacks


Packet fragment attacks include attacks from many fragments, attacks from many packets with offsets, attacks from repeated packet fragments, Tear Drop attacks, Syndrop attacks, NewTear attacks, Bonk attacks, Nesta attacks, Rose attacks, Fawx attacks, Ping of Death attacks, and Jolt attacks. If an attacker sends error packet fragments to a device, the device consumes a large number of resources to process the error packet fragments, affecting normal services.

To prevent the system from breaking down and to ensure normal network services, enable defense against packet fragment attacks on the device. The device then limits the rate of fragment packets to ensure that the CPU runs properly when the device is being attacked by many packet fragments.


  1. Run system-view

    The system view is displayed.

  2. Run anti-attack fragment enable

    Defense against packet fragment attacks is enabled.

    By default, defense against packet fragment attacks is enabled.

    You can also run the anti-attack enable command in the system view to enable attack defense against all attack packets including packet fragments.

  3. Run anti-attack fragment car cir cir

    The rate limit of packet fragments is set.

    By default, the rate limit of packet fragments is 155000000 bit/s.

Verifying the Configuration

  • Run the display anti-attack statistics fragment command to check statistics on defense against packet fragment attacks on the device.

Updated: 2019-08-07

Document ID: EDOC1100034077

Views: 126318

Downloads: 231

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next