No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


CLI-based Configuration Guide - Security

AR100, AR120, AR150, AR160, AR200, AR1200, AR2200, AR3200, and AR3600 V200R010

This document provides the basic concepts, configuration procedures, and configuration examples in different application scenarios of the network management feature supported by the device.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Adjusting the Step of ACL Rules

Adjusting the Step of ACL Rules


During routine maintenance, you may need to add rules to an ACL to meet new service requirements. If the default step 5 is used (the system allocates 5, 10, 15... as rule IDs), you can insert only four rules (rules 6, 7, 8, and 9) between neighboring rules. If you need to insert more than 4 rules between neighboring rules, increase the step to a value greater than 6. Then the system reallocates IDs (6, 12, 18...) to the rules, and you can insert more than four rules (rules 7, 8, 9, 10, and 11) between neighboring rules.

For details about the step, see Step.


  1. Run system-view

    The system view is displayed.

  2. You can create a numbered or named ACL.

    • Run the acl [ number ] acl-number [ match-order { auto | config } ] command to create a numbered ACL (2000-4999 or 6000-6031) and enter the ACL view.

    • Run the acl name acl-name [ advance | basic | link | acl-number ] [ match-order { auto | config } ] command to create a named ACL and enter the ACL view.

    By default, no ACL exists on the device.

    For details about the numbered and named ACLs, see ACL Classification.

  3. Run step step

    The step is set.

    The default step is 5.

Updated: 2019-08-07

Document ID: EDOC1100034077

Views: 125650

Downloads: 230

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next