No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - Security

AR100, AR120, AR150, AR160, AR200, AR1200, AR2200, AR3200, and AR3600 V200R010

This document provides the basic concepts, configuration procedures, and configuration examples in different application scenarios of the network management feature supported by the device.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Application Scenarios for Keychains

Application Scenarios for Keychains

Keychain provides authentication for applications. The following application protocols support Keychain authentication: Routing Information Protocol (RIP), Intermediate System to Intermediate System (IS-IS), Open Shortest Path First (OSPF), Border Gateway Protocol (BGP), and Multicast Source Discovery Protocol (MSDP). Applications use the same Keychain authentication procedures. Create a Keychain and then use the Keychain to perform an authentication.

IS-IS Using Keychain for Authentication

IS-IS is a commonly used routing protocol, and IS-IS security is needed. You can configure a fixed authentication algorithm and key to authenticate IS-IS packets. But fixed authentication algorithms and keys may be decrypted. The use of Keychain to authenticate the IS-IS packets makes IS-IS more secure.

As shown in Figure 19-7, Router A, Router B, Router C, Router D, and Router E use IS-IS to communicate. Router A, Router B, and Router C belong to area 10; Router D and Router E belong to area 20. Router A and Router B are Level-1 devices; Router D and Router E are Level-2 devices; Router C is a Level-1-2 device. Create a Keychain on each device to authenticate the IS-IS packets. Configure area and domain authentication in the IS-IS process, and configure interface authentication on the interface as well.

Figure 19-7  IS-IS using Keychain for authentication
Translation
Download
Updated: 2019-05-20

Document ID: EDOC1100034077

Views: 113896

Downloads: 210

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next