No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - Security

AR100, AR120, AR150, AR160, AR200, AR1200, AR2200, AR3200, and AR3600 V200R010

This document provides the basic concepts, configuration procedures, and configuration examples in different application scenarios of the network management feature supported by the device.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Unbound Hosts Can Go Online After IP and MAC Bindings Are Configured

Unbound Hosts Can Go Online After IP and MAC Bindings Are Configured

Fault Description

After IP and MAC bindings are configured, the unbound hosts can go online.

Procedure

  1. Check whether static binding entries have been configured.

    Run the display dhcp static user-bind { { interface interface-type interface-number | ip-address ip-address | mac-address mac-address | vlan vlan-id } * | all } command to view static binding entries.

    If no static binding entries exist, the IP addresses and MAC addresses may not be correctly bound. Check whether the IP addresses and MAC addresses are bound using the arp static ip-address mac-address command. This command configures static ARP, but not IPSG. Static ARP cannot prevent unbound hosts from going online.

  2. Configure static binding entries.

    Run the user-bind static { { ip-address | ipv6-address } { start-ip [ to end-ip ] } &<1-10> | mac-address mac-address } * [ interface interface-type interface-number ] [ vlan vlan-id [ ce-vlan ce-vlan-id ] ] command to configure static binding entries.

    After the binding entries are configured, run the ip source check user-bind enable command on the specified interface or VLAN. Then unbound hosts cannot go online.

Translation
Download
Updated: 2019-08-07

Document ID: EDOC1100034077

Views: 137502

Downloads: 244

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next