No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


CLI-based Configuration Guide - Security

AR100, AR120, AR150, AR160, AR200, AR1200, AR2200, AR3200, and AR3600 V200R010

This document provides the basic concepts, configuration procedures, and configuration examples in different application scenarios of the network management feature supported by the device.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Example for Setting the Rate Limit in pps for Traffic Suppression

Example for Setting the Rate Limit in pps for Traffic Suppression

Networking Requirements

As shown in Figure 10-2, RouterA is connected to a Layer 2 network and a Layer 3 RouterB. To limit the number of broadcast, multicast, or unknown unicast packets forwarded on the Layer 2 network, you can set the rate limit in pps on Ethernet 2/0/0.

Figure 10-2  Network diagram of Setting the Rate Limit in pps for Traffic Suppression

Configuration Roadmap

The configuration roadmap is as follows:

  • Set the rate limit in pps for traffic suppression on Ethernet 2/0/0.


  1. Enter the interface view.

    <Huawei> system-view
    [Huawei] sysname RouterA
    [RouterA] interface ethernet 2/0/0

  2. Set the rate limit in pps for broadcast packets.

    [RouterA-Ethernet2/0/0] broadcast-suppression packets 12600

  3. Set the rate limit in pps for multicast packets.

    [RouterA-Ethernet2/0/0] multicast-suppression packets 25200

  4. Set the rate limit in pps for unknown unicast packets.

    [RouterA-Ethernet2/0/0] unicast-suppression packets 12600
    [RouterA-Ethernet2/0/0] return

  5. Verify the configuration.

    Run the display flow-suppression interface command, and you can view the traffic suppression configuration on Ethernet 2/0/0.

    [RouterA] display flow-suppression interface Ethernet 2/0/0
     storm type         rate mode   set rate value                                  
     unknown-unicast    pps         pps: 12600(packet/s)                            
     multicast          pps         pps: 25200(packet/s)                            
     broadcast          pps         pps: 12600(packet/s)                            

Configuration Files

Configuration files on RouterA

 sysname RouterA 
interface Ethernet2/0/0
 unicast-suppression packets 12600
 multicast-suppression packets 25200
 broadcast-suppression packets 12600  
Updated: 2019-08-07

Document ID: EDOC1100034077

Views: 137104

Downloads: 244

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next