No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - AMI

AR500, AR510, AR531, AR550, AR1500, and AR2500 V200R010

This document describes the principles and configurations of the AMI features, and provides configuration examples of these features.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Basic Parameters for Communication Between the Device and Meters

Configuring Basic Parameters for Communication Between the Device and Meters

Context

To implement communication between the device and a meter, configure basic parameters for the communication, including the meter type, phase type, and protocol type.

Procedure

  1. Run the system-view command to enter the system view.
  2. Run the ami command to enter the AMI view.
  3. Run the meter meter-id command to set the measurement point ID.
  4. Run the parameter phase phase-type command to set the meter phase type.

    By default, the phase type of a meter is single-phase.

  5. Run the parameter protocol-type protocol-type [ address communication-address ] [ authorization level ] command to set the protocol type, protocol communication address, and authentication level.

    By default, the protocol type is iec62056, protocol communication address is empty,, and authentication level is non-authentication.

  6. Run the parameter channel-type tunnel [ baud-rate rate-value ] [ databits databits ] [ parity parity ] [ stopbits stopbits ] command to set meter channel parameters, including the channel ID, baud rate, meter check data bit, meter parity check bit, and meter check stop bit.

    By default, the specified meter channel is RS485-0, baud rate is 9600 bit/s, check data bit is 8 bit, check stop bit is 1 bit, and there is no parity bit.

  7. Run the parameter validity { enable | disable } command to set the validity of meter parameters.

    By default, the validity of meter parameters is disabled, indicating that meter data is not collected.

  8. Run the parameter rate-num rate-num command to set the number of meter rates.

    By default, four meter rates are available.

  9. (Optional) Run the parameter logic-device-name logic-device-name command to configure the logical device name of a meter.

    By default, the logical device name of a meter is empty.

Translation
Download
Updated: 2019-03-07

Document ID: EDOC1100034224

Views: 10040

Downloads: 20

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next