No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - AMI

AR500, AR510, AR531, AR550, AR1500, and AR2500 V200R010

This document describes the principles and configurations of the AMI features, and provides configuration examples of these features.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring the Connection Type

Configuring the Connection Type

Context

When the device functions as the TCP client to communicate with the remote end, you can set the timeout period and interval for the connection between the device and remote end in addition to specifying the remote IP address and port number. If the device does not connect to the remote end when the connection timeout period expires, the device sends an instruction again to request the connection after the connection interval times out.

Procedure

  1. Run the system-view command to enter the system view.
  2. Run the ami command to enter the AMI view.
  3. Run the connection connection-name command to configure the connection name and enter the connection view.
  4. Run the parameter protocol-type { iec62056 | modbus } command to set the communication protocol type of a front-end processor connecting to the device.
  5. Run the parameter connection-type tcp-client { remote address port port-num | time-out time | retry-wait interval-value } * command to set the local connection type, remote IP address, remote port number, and timeout period and interval of the connection with the remote end on the device.
  6. (Optional) Run the set net timeout time-value command to set the timeout period of the Ethernet data request between the device and front-end processors. By default, the timeout period of Ethernet data requests is 30s.
Translation
Download
Updated: 2019-03-07

Document ID: EDOC1100034224

Views: 10041

Downloads: 20

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next