No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - Basic Configuration

AR500, AR510, AR531, AR550, AR1500, and AR2500 V200R010

This document provides the basic concepts, configuration procedures, and configuration examples in different application scenarios of the Basic configuration supported by the device.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Set Boot File

Set Boot File

Access the startup select submenu and select 2 to access the set boot file menu.

Before upgrading or degrading the system, specify the system software used for startup using this menu.

Select the serial number of the storage device where the system software locates. The storage device can be the flash memory, micro SD card, or USB disk.

        Startup Select

    1. Display Startup
    2. Set Boot File
    3. Set Config File
    4. Startupfile Check Manage
    5. Set Startup Waiting Time
    0. return

Enter your choice(0-5):2
        Select Boot File

    1. Flash
    2. SDCard[1]
    0. Return

Enter your choice(0-2):2
NOTE: Boot file must be .cc or .CC

Current boot file: flash:/softwarenew.cc
Press ENTER directly for no change.
Or, please input the new file name: flash:/softwarenew1.cc
Save the boot file name: flash:/softwarenew1.cc ? Yes or No(Y/N)y
Save load state word...OK!

For the AR515GW-LM9-D, if the check flag for the digital signature file of the system software is set based on Startupfile Check Manage, the procedure for specifying the startup system software is as follows:

        Startup Select

    1. Display Startup
    2. Set Boot File
    3. Set Config File
    4. Startupfile Check Manage
    5. Set Startup Waiting Time
    0. return

Enter your choice(0-5):2
        Select Boot File

    1. flash
    0. Return

Enter your choice(0-1):1
NOTE: Boot file must be .cc or .CC

Current boot file: flash:/software.cc
Press ENTER directly for no change.
Or, please input the new file name: flash:/softwarenew.cc
        Signature file Select                                                                                                       
                                                                                                                                    
    0. Flash                                                                                                                        
                                                                                                                                    
Enter your choice(0-0): 0
Input the signature file: flash:/softwarenew.cc.asc
 Verifying,This may last a few minutes.Please Wait......
 Step1: Pre-deal with keyfile in start packet ...OK
 Step2: Pre-deal with applied signature file ...OK
 Step3: Pre-deal with target boot file ...OK
 Step4: Verifying Data......OK
 signature file check success!

Signature check success!
Save the boot file name: falsh:/softwarenew.cc ? Yes or No(Y/N) Y
Save load state word...OK!
Translation
Download
Updated: 2019-05-20

Document ID: EDOC1100034225

Views: 45073

Downloads: 100

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next