No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - Basic Configuration

AR500, AR510, AR531, AR550, AR1500, and AR2500 V200R010

This document provides the basic concepts, configuration procedures, and configuration examples in different application scenarios of the Basic configuration supported by the device.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Maintaining Auto-Config

Maintaining Auto-Config

You can monitor the running status of Auto-Config in each phase to ensure that Auto-Config runs normally.

Procedure

  1. Five minutes after devices without any configuration file are powered on, check address allocation on the DHCP server to determine whether devices are connected to the network. Run the display ip pool { interface interface-pool-name | name ip-pool-name } used command to check the IP addresses that the DHCP server assigns to devices to be configured.

    NOTE:

    If the device is connected to the network, you can Telnet to the device but do not configure the device.

  2. Five minutes after devices obtain IP addresses, check the file transmission log on the file server, or log in to the devices to check whether correct system software, patch files, and configuration files have been downloaded and check the running status of Auto-Config using the display autoconfig-status command.

    NOTE:
    • Do not save configuration immediately to a device after the configuration file is downloaded; otherwise, only a temporary configuration file is saved because the configuration has not taken effect.

    • If devices fail to obtain the files, the Auto-Config process is suspended. Run the autoconfig getting-file restart command to obtain the system software, patch file, and configuration file to resume the Auto-Config process.

  3. After the configuration file is downloaded successfully, the device is restarted according to the setting of Option 146.
    1. Run the display autoconfig activating-config delay command to check the configured delay in restarting the device.
    2. Run the display autoconfig activating-config remanent-time command to check the remaining delay in restarting the device.
Translation
Download
Updated: 2019-05-20

Document ID: EDOC1100034225

Views: 45071

Downloads: 100

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next