No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - Basic Configuration

AR500, AR510, AR531, AR550, AR1500, and AR2500 V200R010

This document provides the basic concepts, configuration procedures, and configuration examples in different application scenarios of the Basic configuration supported by the device.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Logging In to a Device Through STelnet

Logging In to a Device Through STelnet

This section describes how to log in to a device using STelnet.

Context

After completing SSH user and STelnet server configurations on a device, you can use STelnet software on a PC to log in to the device. Assume that password authentication is configured for SSH users and the management IP address of the device is 10.137.217.203. The third-party software, PuTTY, is used as an example to illustrate the STelnet login process.

Procedure

  1. Start the PuTTY software, enter the device's IP address and port and select the SSH protocol.

    Figure 9-5  Logging in to an SSH server through PuTTY in password authentication mode

  2. Click Open. In the displayed page, enter the user name and password and press Enter to log in to the device through STelnet.

    login as: client001      //Enter the SSH user name.
    Sent username "client001"
    
    client001@10.137.217.203's password:           //Enter the password configured through AAA.
    
    <SSH Server>

Verifying the Configuration

  • Run the display ssh user-information [ username ] command to check information about SSH users on the SSH server. If no SSH user is specified, information about all SSH users logging in to the SSH server is displayed.
  • Run the display ssh server status command to check global configurations of the SSH server.
  • Run the display ssh server session command to check information about sessions between the SSH server and client.
Translation
Download
Updated: 2019-05-20

Document ID: EDOC1100034225

Views: 44795

Downloads: 100

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next