No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - IP Multicast

AR500, AR510, AR531, AR550, AR1500, and AR2500 V200R010

This document describes the concepts and configuration procedures of IP Service features on the device, and provides the configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Verifying the Basic MLD Function Configuration

Verifying the Basic MLD Function Configuration

Context

After basic MLD functions are configured, run the following commands in any view to check the MLD configuration, running status, and information about receiver hosts.

Procedure

  • Run the display mld interface [ interface-type interface-number | up | down ] [ verbose ] command to check the MLD information on an interface.
  • Run the display mld group [ ipv6-group-address | interface interface-type interface-number ] * [ verbose ] command to check information about MLD groups that hosts have dynamically joined by sending Multicast Listener Report messages.
  • Run the following commands to check information about receiver hosts in a static MLD multicast group:

    • Run the display mld group [ ipv6-group-address ] static [ up | down ] [ verbose ] command to check information about the Up or Down interface in a static MLD multicast group.
    • Run the display mld group [ ipv6-group-address ] static interface-number command to check the number of interfaces in a static MLD multicast group.
    • Run the display mld group [ ipv6-group-address ] interface interface-type interface-number static [ verbose ] command to check information about a static MLD multicast group on a specified interface.
    • Run the display mld group static interface interface-type interface-number entry-number command to check the number of static MLD multicast groups on a specified interface.

Translation
Download
Updated: 2019-08-09

Document ID: EDOC1100034230

Views: 123485

Downloads: 37

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next