No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


CLI-based Configuration Guide - IP Multicast

AR500, AR510, AR531, AR550, AR1500, and AR2500 V200R010

This document describes the concepts and configuration procedures of IP Service features on the device, and provides the configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) Associating IGMP Proxy with NQA

(Optional) Associating IGMP Proxy with NQA


Internet Group Management Protocol (IGMP) proxy lacks a fault detection mechanism to trigger link switchover quickly. Therefore, multicast services may be interrupted for a long time when a link failure occurs. You can solve this problem by associating IGMP proxy with a network quality analysis (NQA) test instance.

After IGMP proxy is associated with an NQA test instance, it can use the NQA test instance to monitor end-to-end link status. When the NQA test instance detects a link failure on the upstream interface, the device configured with the IGMP proxy backup function can switch multicast traffic to the backup link to minimize the communication interruption time.


  1. Run system-view

    The system view is displayed.

  2. Run nqa test-instance admin-name test-name

    An NQA test instance is created and the test instance view is displayed.

  3. Run test-type icmp

    The test type is set to ICMP.

  4. Run destination-address ipv4 ipv4-address

    The destination IP address for the ICMP test instance is configured.

  5. Run quit

    Return to the system view.

  6. Run interface interface-type interface-number

    The upstream interface view is displayed.

  7. Run igmp proxy track nqa admin-name test-name

    IGMP proxy is associated with the NQA test instance.

    By default, IGMP proxy on an interface is not associated with any NQA test instance.

    The preceding procedure provides the basic configuration of an ICMP test instance. For details about NQA test instance configurations, see "NQA Configuration" in the Huawei AR Series IOT Gateway Configuration Guide - Network Management.

Updated: 2019-08-09

Document ID: EDOC1100034230

Views: 122619

Downloads: 37

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next