No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - IP Multicast

AR500, AR510, AR531, AR550, AR1500, and AR2500 V200R010

This document describes the concepts and configuration procedures of IP Service features on the device, and provides the configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring a Multicast Group Policy

Configuring a Multicast Group Policy

Context

A multicast group policy determines which multicast groups the hosts in a VLAN can join. The multicast group policy is applicable only to dynamic multicast groups. Before configuring the multicast group policy, create an access control list (ACL) and define rules. For details about ACL configuration, see "ACL Configuration" in the Huawei AR Series IOT Gateway Configuration Guide - Security.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Use either of the following methods to configure a multicast group policy.

    • Configure a multicast group policy in a VLAN.
      1. Run vlan vlan-id

        The VLAN view is displayed.

      2. Run igmp-snooping group-policy acl-number [ version version-number ]

        A multicast group policy is configured.

    • Configure a multicast group policy on an interface.
      1. Run interface interface-type interface-number

        The interface view is displayed.

      2. Run igmp-snooping group-policy acl-number [ version version-number ] vlan vlan-id1 [ to vlan-id2 ]

        A multicast group policy is configured on an interface.

    By default, the user hosts in a VLAN can join any multicast group. If the IGMP version is not specified for a multicast group policy, the industrial switch router applies the policy to all the received IGMP messages regardless of their versions.

    If you configure multicast group policies for the same VLAN in the interface view and VLAN view, the system first uses the policy configured in the interface view and then the policy configured in the VLAN view to determine the groups that user hosts can join.

    NOTE:

    The ACL referenced in a group policy permits all multicast groups by default. Therefore, to allow interfaces in a VLAN to receive only multicast data sent to specific groups, use a rule deny source any rule with permit rules in the ACL.

Translation
Download
Updated: 2019-08-09

Document ID: EDOC1100034230

Views: 122286

Downloads: 37

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next