No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


CLI-based Configuration Guide - IP Multicast

AR500, AR510, AR531, AR550, AR1500, and AR2500 V200R010

This document describes the concepts and configuration procedures of IP Service features on the device, and provides the configuration examples.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Basic MLD Snooping Functions

Configuring Basic MLD Snooping Functions


After basic MLD snooping is configured, the device can generate and maintain the IPv6 Layer 2 multicast forwarding table to distribute multicast data to the receivers at the data link layer as service requires.

Pre-configuration Tasks

Before configuring basic MLD snooping functions, complete the following tasks:
  • Connect interfaces and setting physical parameters on the interfaces so that the physical status of the interfaces becomes Up.
  • Create VLANs.
  • Add interfaces to VLANs.

Configuration Procedure

Only Enabling MLD Snooping and Configuring MLD Snooping Version are mandatory. The other tasks can be selected according to your requirements.

Updated: 2019-08-09

Document ID: EDOC1100034230

Views: 138073

Downloads: 41

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next