No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - IP Multicast

AR500, AR510, AR531, AR550, AR1500, and AR2500 V200R010

This document describes the concepts and configuration procedures of IP Service features on the device, and provides the configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) Configuring the Range of Multicast Groups That an Interface Can Join

(Optional) Configuring the Range of Multicast Groups That an Interface Can Join

Context

To limit the range of IPv6 multicast groups that an interface can join, configure ACL6 rules to filter received Multicast Listener Report messages so that the interface maintains multicast membership only in the allowed multicast groups.

Before specifying the range of multicast groups that an interface can join, configure an IPv6 access control list (ACL6) to define the range of multicast groups. For details about the ACL6 configuration, see "ACL Configuration" in the Huawei AR Series IOT Gateway Configuration Guide - Security.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run interface interface-type interface-number

    The interface view is displayed.

  3. Run mld group-policy { acl6-number | acl6-name acl6-name } [ 1 | 2 ]

    The range of multicast groups that the interface can join is configured.

    By default, an interface can join any multicast group.

    NOTE:

    When configuring an ACL6 rule for an interface, use the permit parameter in the rule command to allow hosts connected to the interface to join groups within the specified range. If no rule is configured in the ACL6, hosts connected to the interface cannot join any multicast groups.

Translation
Download
Updated: 2019-08-09

Document ID: EDOC1100034230

Views: 129879

Downloads: 39

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next