No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


CLI-based Configuration Guide - IP Multicast

AR500, AR510, AR531, AR550, AR1500, and AR2500 V200R010

This document describes the concepts and configuration procedures of IP Service features on the device, and provides the configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) Configuring the MLD Message Suppression Time

(Optional) Configuring the MLD Message Suppression Time


Multicast Listener Discovery (MLD) periodically sends Query and Response messages to maintain group memberships. If multiple members join the same multicast group, they all send Report messages of the multicast group to the MLD querier. As a result, the MLD querier receives duplicate Report messages. To reduce the number of MLD messages processed by the MLD querier, the downstream Layer 2 multicast devices can suppress duplicate Report messages. The default MLD message suppression time is 10 seconds. You can change the MLD message suppression time using a command.

After you set the MLD message suppression time on a Layer 2 multicast device, the device acts as follows:

  • After the Layer 2 device receives an MLD Report message, it does not forward identical MLD Report messages to the router port within the suppression time.
  • If the Layer 2 device receives an MLD General Query message or Multicast-Address-Specific Query message within the suppression time, it does not suppress the first MLD Report message sent in response to the Query message. In addition, the Layer 2 device resets the suppression timer when receiving the first MLD Report message.


  1. Run system-view

    The system view is displayed.

  2. Run mld-snooping suppression-time suppression-time

    The MLD message suppression time is configured.

    By default, the MLD message suppression time is 10 seconds.

Updated: 2019-08-09

Document ID: EDOC1100034230

Views: 123692

Downloads: 37

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next