No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


CLI-based Configuration Guide - IP Multicast

AR500, AR510, AR531, AR550, AR1500, and AR2500 V200R010

This document describes the concepts and configuration procedures of IP Service features on the device, and provides the configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Summary of MLD Snooping Configuration Tasks

Summary of MLD Snooping Configuration Tasks

Table 10-3 lists MLD snooping configuration tasks.

Table 10-3  MLD snooping configuration tasks



Configuring Basic MLD Snooping Functions

On an IPv6 network, when multicast data is forwarded to a Layer 2 multicast device connected to a user network segment, configure MLD snooping on the Layer 2 multicast device to prevent multicast data from being flooded in the broadcast domain and to accurately forward multicast data at Layer 2. After MLD snooping is configured, the Layer 2 multicast device can snoop and analyze MLD messages between multicast users and the upstream router. The Layer 2 multicast device sets up Layer 2 multicast forwarding entries to control forwarding of multicast data. In this way, multicast data is not broadcast on the Layer 2 network.

Configuring the MLD Snooping Policy

To filter out multicast messages on a Layer 2 multicast device or limit the range of multicast groups that hosts can join, configure an MLD snooping policy on the Layer 2 multicast device.

Configuring Membership Fast-Update

To improve running efficiency of multicast services and user experience, configure quick membership update on a Layer 2 multicast device so that the Layer 2 multicast device quickly updates entries when receiver hosts join or leave a multicast group.

Updated: 2019-08-09

Document ID: EDOC1100034230

Views: 123453

Downloads: 37

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next