No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - IP Multicast

AR500, AR510, AR531, AR550, AR1500, and AR2500 V200R010

This document describes the concepts and configuration procedures of IP Service features on the device, and provides the configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring RPF Check Policies

Configuring RPF Check Policies

Pre-configuration Tasks

Before configuring an RPF check policy, complete the following tasks:

  • Configure a unicast routing protocol to ensure normal unicast routing on the network.
  • Run the multicast routing-enable command in the system view to enable Layer 3 multicast routing globally.

Configuration Procedure

The following configuration tasks can be performed in any sequence.

Translation
Download
Updated: 2019-08-09

Document ID: EDOC1100034230

Views: 123878

Downloads: 37

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next