No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


CLI-based Configuration Guide - IP Multicast

AR500, AR510, AR531, AR550, AR1500, and AR2500 V200R010

This document describes the concepts and configuration procedures of IP Service features on the device, and provides the configuration examples.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Summary of MLD Configuration Tasks

Summary of MLD Configuration Tasks

Table 3-5 lists MLD configuration tasks.

Table 3-5  MLD configuration tasks



Configuring Basic MLD Functions

To enable receiver hosts to join an IPv6 multicast network and receive multicast data, you must configure basic MLD functions on the industrial switch router interface connected to the receiver hosts.

Optimizing MLD Performance

After basic MLD functions are configured on the multicast industrial switch router, the industrial switch router can exchange MLD messages with member hosts to maintain group membership with the default configurations. You can optimize MLD performance on the industrial switch router according to requirements of network security and performance optimization.

Configuring MLD SSM Mapping

The SSM model allows MLDv2 hosts to specify the multicast sources from which they want to receive data. In some cases, receiver hosts can run only MLDv1. To allow these hosts to use SSM, configure MLD SSM mapping on the industrial switch router to provide the SSM service for MLDv1 receiver hosts.

Configuring MLD Limit

As defined in the MLD protocol, group members can join or leave a multicast group anytime, anywhere, and the number of group memberships is not limited. When many users watch multiple programs simultaneously, a lot of bandwidth on the multicast device is consumed, leading to degradation of device performance. To prevent this problem, you can configure MLD limit on the industrial switch router to limit the number of multicast groups on an interface or in the system. This ensures that users watch clear, stable programs.

Updated: 2019-08-09

Document ID: EDOC1100034230

Views: 137173

Downloads: 41

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next