No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - IP Multicast

AR500, AR510, AR531, AR550, AR1500, and AR2500 V200R010

This document describes the concepts and configuration procedures of IP Service features on the device, and provides the configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Adjusting Graft Control Parameters

Adjusting Graft Control Parameters

Context

To quickly resume multicast forwarding to a pruned network segment, the industrial switch router sends a Graft message to its upstream neighbor and starts a timer on the upstream interface. If the industrial switch router does not receive multicast data when the timer expires, it sends another Graft message to the upstream neighbor.

Default Settings

The default retransmission interval of Graft messages is 3s.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run interface interface-type interface-number

    The interface view is displayed.

  3. Run pim ipv6 timer graft-retry interval

    The retransmission interval of Graft messages is configured.

Verifying the Configuration

After adjusting the retransmission interval of Graft messages on an interface, check IPv6 PIM-DM graft information and IPv6 PIM information on the interface to see whether the configuration meets the service requirements.

  • Run the display pim ipv6 interface [ interface-type interface-number | up | down ] [ verbose ] command in any view to check IPv6 PIM information on an interface.

  • Run the display pim ipv6 grafts command to check information about IPv6 PIM-DM Graft messages that have not been acknowledged by the upstream neighbor.

Translation
Download
Updated: 2019-08-09

Document ID: EDOC1100034230

Views: 122880

Downloads: 37

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next