No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


CLI-based Configuration Guide - IP Multicast

AR500, AR510, AR531, AR550, AR1500, and AR2500 V200R010

This document describes the concepts and configuration procedures of IP Service features on the device, and provides the configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Default Settings for IPv6 Multicast Route Management

Default Settings for IPv6 Multicast Route Management

Table 8-8 lists the default settings for IPv6 multicast route management.

Table 8-8  Default settings for IPv6 multicast route management
Parameter Default Setting

IPv6 multicast load splitting

Not configured. If multiple equal-cost optimal routes are found in a reverse path forwarding (RPF) check, the system selects the route with the largest next-hop address as the RPF route.

IPv6 multicast boundary

Not configured.

Updated: 2019-08-09

Document ID: EDOC1100034230

Views: 129129

Downloads: 38

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next