No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


CLI-based Configuration Guide - IP Multicast

AR500, AR510, AR531, AR550, AR1500, and AR2500 V200R010

This document describes the concepts and configuration procedures of IP Service features on the device, and provides the configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Clearing MLD Snooping Entries

Clearing MLD Snooping Entries


MLD snooping entries are classified into static and dynamic entries, and they are cleared in different ways.

Static entries cannot be restored after being cleared and can be created when you configure static member ports.

After you clear the dynamic entries, hosts in a VLAN cannot receive certain multicast flows. The hosts receive the multicast flows again only after the hosts send MLD Report messages and the forwarding entries are regenerated on the device.


  • Run the undo mld-snooping static-group { group-ipv6-address [ source source-ipv6-address ] vlan vlan-id | all } command in the interface view to remove an interface from a static multicast group.
  • Run the reset mld-snooping group { all | vlan vlan-id } or reset mld-snooping group group-ipv6-address [ source-address source-ipv6-address ] vlan vlan-id command in the user view to clear dynamic group entries.
Updated: 2019-08-09

Document ID: EDOC1100034230

Views: 127591

Downloads: 38

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next