No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


CLI-based Configuration Guide - IP Multicast

AR500, AR510, AR531, AR550, AR1500, and AR2500 V200R010

This document describes the concepts and configuration procedures of IP Service features on the device, and provides the configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring IGMP SSM Mapping

Configuring IGMP SSM Mapping

Pre-configuration Tasks

Enabling IGMP


The source-specific multicast (SSM) model allows IGMPv3 hosts to specify the multicast sources which they want to receive data from. However, some hosts can only run IGMPv1 or IGMPv2. To enable these hosts to use the SSM service, configure IGMP SSM mapping on the industrial switch router. IGMP SSM mapping is implemented based on static SSM mapping entries on the industrial switch router. The industrial switch router converts (*, G) information in IGMPv1 and IGMPv2 Report messages to (S, G) information according to static SSM mapping entries to provide the SSM service for IGMPv1 and IGMPv2 hosts. By default, SSM group addresses range from to You can expand this range if required. For details, see (Optional) Configuring an SSM Group Policy.


  1. Run system-view

    The system view is displayed.

  2. Run interface interface-type interface-number

    The interface view is displayed.

  3. Run igmp ssm-mapping enable

    IGMP SSM mapping is enabled on the interface.

    By default, IGMP SSM mapping is disabled on an interface.

    Enable IGMPv3 on industrial switch router interfaces to ensure that hosts running any IGMP version on a network segment can obtain the SSM service.

  4. Run quit

    Return to the system view.

  5. Run igmp [ vpn-instance vpn-instance-name ]

    The IGMP view is displayed.

  6. Run ssm-mapping group-address { group-mask | group-mask-length } source-address

    An SSM mapping rule is configured to map a group address to a multicast source.

    By default, no SSM mapping rule is configured.

Verifying the Configuration

Run the following commands in any view to check the configured mapping entries and whether IGMP SSM mapping is enabled on the interface.

  • Run the display igmp [ vpn-instance vpn-instance-name | all-instance ] group [ group-address | interface interface-type interface-number ]* ssm-mapping [ verbose ] command to check information about group memberships established with IGMP SSM mapping.
  • Run the display igmp [ vpn-instance vpn-instance-name | all-instance ] ssm-mapping { group [ group-address ] | interface [ interface-type interface-number ] } command to check SSM mapping entries configured and whether IGMP SSM mapping is enabled on an interface.
Updated: 2019-08-09

Document ID: EDOC1100034230

Views: 127511

Downloads: 38

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next