Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Verifying the Basic IGMP Snooping Function Configuration
Context
After the configurations are complete, run the following commands in any view to check IGMP spooning configurations and the forwarding entries.
Procedure
- Run the display igmp-snooping [ vlan [ vlan-id ] ] configuration command to check the IGMP snooping configuration in a VLAN.
- Run the display igmp-snooping [ vlan [ vlan-id ] ] command to check all the IGMP snooping running parameters in a VLAN.
- Run the display igmp-snooping port-info [ vlan vlan-id [ group-address group-address ] ] [ verbose ] command to check member ports of the multicast group.
- Run the display igmp-snooping router-port vlan vlan-id command to check router ports.
- Run the display l2-multicast forwarding-table vlan vlan-id [ [ source-address source-address ] group-address { group-address | router-group } ] command to check the layer-2 multicast forwarding table in a VLAN.
- Run the display igmp-snooping querier vlan [ vlan-id ] command to check the IGMP snooping querier configuration.