No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


CLI-based Configuration Guide - IP Multicast

AR500, AR510, AR531, AR550, AR1500, and AR2500 V200R010

This document describes the concepts and configuration procedures of IP Service features on the device, and provides the configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Enabling MLD

Enabling MLD


IPv6 multicast routing is the prerequisite for configuring all IPv6 multicast functions. You must enable IPv6 multicast routing before configuring an IPv6 multicast protocol.

Before configuring Multicast Listener Discovery (MLD) on a multicast industrial switch router, enable MLD on an interface connected to receiver hosts.


  1. Run system-view

    The system view is displayed.

  2. Run multicast ipv6 routing-enable

    IPv6 multicast routing is enabled.

  3. Run interface interface-type interface-number

    The interface view is displayed.

  4. Run mld enable

    MLD is enabled on the interface.

    By default, MLD is disabled on an interface.


    If IPv6 PIM and MLD need to be enabled on the same interface, enable IPv6 PIM and MLD in sequence.

Updated: 2019-08-09

Document ID: EDOC1100034230

Views: 123800

Downloads: 37

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next