No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


CLI-based Configuration Guide - IP Multicast

AR500, AR510, AR531, AR550, AR1500, and AR2500 V200R010

This document describes the concepts and configuration procedures of IP Service features on the device, and provides the configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Enabling MSDP

Enabling MSDP


To enable all rendezvous points (RPs) on a network to share source information and to minimize the number of MSDP—enabled devices, it is recommended that you configure MSDP only on the RPs on the network.

After MSDP is enabled, the MSDP view is displayed. You can perform other MSDP configurations in the MSDP view. Enabling MSDP is the prerequisite for other MSDP configurations.


  1. Run system-view

    The system view is displayed.

  2. Run msdp [ vpn-instance vpn-instance-name ]

    MSDP is enabled and the MSDP view is displayed.

Updated: 2019-08-09

Document ID: EDOC1100034230

Views: 123773

Downloads: 37

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next