No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - IP Multicast

AR500, AR510, AR531, AR550, AR1500, and AR2500 V200R010

This document describes the concepts and configuration procedures of IP Service features on the device, and provides the configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) Configuring a Static Member Port

(Optional) Configuring a Static Member Port

Context

A member port is on a Layer 2 device and connects to receiver hosts which are multicast group members. The member port can be configured manually or learned dynamically by multicast protocols. When IGMP snooping is enabled in a VLAN, all interfaces in this VLAN learn forwarding entries from multicast packets. When an interface receives IGMP Report messages, the Layer 2 device sets this interface as a dynamic member port. A dynamic member port has the aging time.

If the hosts connected to an interface need to receive the multicast data of a specific multicast group or multicast source group for a long time, add the interface statically to the multicast group or multicast source group. The manually added interface is a static member port. Static member ports do not age.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run interface interface-type interface-number

    The interface view is displayed.

  3. (Optional) Run undo igmp-snooping learning vlan { { vlan-id1 [ to vlan-id2 ] } &<1-10> | all }

    Dynamic learning of member ports is disabled.

    By default, dynamic learning of member ports is enabled. To forward multicast data, the interfaces must be statically added to a multicast group after disabling dynamic learning of member ports.

  4. Run l2-multicast static-group [ source-address source-ip-address ] group-address group-ip-address vlan { vlan-id1 [ to vlan-id2 ] } &<1-10>

    The interface is manually added to a multicast group and becomes a static member port.

    Or run l2-multicast static-group [ source-address source-ip-address ] group-address group-ip-address1 to group-ip-address2 vlan vlan-id

    The interface is added to multiple multicast groups.

Translation
Download
Updated: 2019-08-09

Document ID: EDOC1100034230

Views: 121500

Downloads: 37

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next