No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


CLI-based Configuration Guide - IP Multicast

AR500, AR510, AR531, AR550, AR1500, and AR2500 V200R010

This document describes the concepts and configuration procedures of IP Service features on the device, and provides the configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring the Maximum Number of Downstream Nodes in an IPv6 Multicast Forwarding Entry

Configuring the Maximum Number of Downstream Nodes in an IPv6 Multicast Forwarding Entry


When the industrial switch router receives a multicast packet, it copies the packet for each downstream node in the matching IPv6 multicast forwarding entry. If there are too many downstream nodes, the industrial switch router is overloaded. To reduce the load on the industrial switch router, limit the number of downstream nodes in each IPv6 multicast forwarding entry.

Default Settings

By default, an IPv6 multicast forwarding entry can contain a maximum of 128 downstream nodes.


  1. Run system-view

    The system view is displayed.

  2. Run multicast ipv6 forwarding-table downstream-limit limit

    The maximum number of downstream nodes in an IPv6 multicast forwarding entry is configured.

Updated: 2019-08-09

Document ID: EDOC1100034230

Views: 122765

Downloads: 37

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next