No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


CLI-based Configuration Guide - IP Multicast

AR500, AR510, AR531, AR550, AR1500, and AR2500 V200R010

This document describes the concepts and configuration procedures of IP Service features on the device, and provides the configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Adjusting the Interval for PIM to Send Trap Messages

Adjusting the Interval for PIM to Send Trap Messages


After Protocol Independent Multicast (PIM) is enabled on the industrial switch routers, you can configure PIM management information base (MIB) notifications to set the interval for sending PIM events. Therefore, you can know the current status of various PIM events on the industrial switch routers in real time. The PIM events include neighbor loss, neighbor addition, receiving invalid Join/Prune messages, RP-mapping change, interface being elected as the designated router (DR), the failure in joining multicast groups because the number of PIM entries reaches the upper limit and the event of receiving invalid Register messages.

Perform the following steps on the industrial switch router managed by the network management system.


  1. Run system-view

    The system view is displayed.

  2. Run multicast-mib

    The multicast MIB view is displayed.

  3. Run pim mib-notification interval { interface-election-dr election-value | invalid-join-prune jp-value | invalid-register register-value | neighbor-loss loss-value | new-neighbor new-value | rp-mapping-change change-value | mrt-limit mrt-value }

    The interval for PIM to send trap messages is set.

    By default, the interval for sending trap messages for neighbor lost and neighbor addition is 0 seconds. That is, once the event occurs, PIM reports it immediately.

    The default interval for sending the trap of event of receiving invalid Join/Prune messages, the RP-mapping change event, the event of the interface being elected as the DR, the failure in joining multicast groups because the number of PIM entries reaches the upper limit or the event of receiving invalid Register messages is 65535 seconds. After the events of these types occur, PIM does not report them.


    To configure PIM to report these events, you can run the pim mib-notification interval command to set an interval smaller than 65535 seconds.

Updated: 2019-08-09

Document ID: EDOC1100034230

Views: 129459

Downloads: 38

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next