No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - IP Service

AR500, AR510, AR531, AR550, AR1500, and AR2500 V200R010

This document describes the concepts and configuration procedures of IP Service features on the device, and provides the configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Global Unicast Addresses for Interfaces

Configuring Global Unicast Addresses for Interfaces

Context

A global unicast address is similar to an IPv4 public address and provided for the Internet Service Provider (ISP). A global unicast address can be generated by either of the following methods:

  • Generated in EUI-64 format: An IPv6 global unicast address in EUI-64 format contains a manually configured prefix and an automatically generated interface identifier.
  • Configured manually: You can manually configure an IPv6 global unicast address.
NOTE:
  • You can configure an interface with multiple global unicast addresses with different network prefixes.

  • Manually configured global unicast addresses have a higher priority than automatically generated ones. Manually configured addresses can overwrite automatically generated ones with the same prefix. The overwritten automatically generated addresses do not take effect even if manually configured addresses are deleted. A device needs to generate a new global unicast address based on the IP prefix carried in the received RA packet.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run ipv6

    IPv6 packet forwarding is enabled.

    By default, IPv6 packet forwarding is disabled.

  3. Run interface interface-type interface-number

    The specified interface view is displayed.

  4. Run ipv6 enable

    The IPv6 function is enabled on the interface.

    By default, the IPv6 function is disabled on an interface.

  5. Run either of the following commands to configure an IPv6 global unicast address for an interface:

    • Run ipv6 address { ipv6-address prefix-length | ipv6-address/prefix-length }

      An IPv6 global unicast address is manually configured.

    • Run ipv6 address { ipv6-address prefix-length | ipv6-address/prefix-length } eui-64

      An IPv6 global unicast address is generated in EUI-64 format.

    You can configure a maximum of 10 global unicast addresses on an interface.

Verifying the Configuration

  • Run the display ipv6 interface [ interface-type interface-number | brief ] command in any view to check IPv6 information about a specified interface.

  • Run the display this ipv6 interface command in the interface view to check IPv6 information about the current interface.

Translation
Download
Updated: 2019-05-20

Document ID: EDOC1100034231

Views: 82687

Downloads: 54

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next