No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - IP Service

AR500, AR510, AR531, AR550, AR1500, and AR2500 V200R010

This document describes the concepts and configuration procedures of IP Service features on the device, and provides the configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Static PMTU

Configuring Static PMTU

Context

Generally, PMTU is dynamically negotiated according to the IPv6 MTU value of an interface. In special situations, to protect devices on the network and avoid attacks from large-sized packets, you can manually configure the PMTU to a specified destination node to control the maximum length of packets forwarded from the device to the destination node.

NOTE:

When the PMTU from the device to a specified destination node is set, the IPv6 MTU values for interfaces on all intermediate devices cannot be smaller than the configured PMTU value. Otherwise, packets are discarded.

Procedure

  1. Run system-view

    The system view is displayed.

  2. (Optional) Configure the IPv6 MTU for an interface.

    1. Run interface interface-type interface-number

      The specified interface view is displayed.

    2. Run ipv6 mtu mtu

      The MTU of IPv6 packets on an interface is set.

      By default, the MTU of IPv6 packets on an interface is 1500 bytes.

      NOTE:
      • For the AR503GW-LM7, AR503GW-Lo, AR503GW-LcM7, AR503EDGW-Lc, AR503EDGW-Lo, AR503EW, AR503HGW-L, AR503HGW-Lc, AR509G-L-D-H, AR509G-Lc, and AR515GW-LM9-D, AR515CGW-L, the default value on the tunnel interface of the IPv6 over IPv4 tunnel is 1480 bytes.
      • After the MTU value is changed, run the shutdown and undo shutdown commands or the restart (interface view) command to restart the interface and allow the changes to take effect.

    3. Run quit

      Return to the system view.

  3. Run ipv6 pathmtu ipv6-address [ vpn-instance vpn-instance-name ] [ path-mtu ]

    The PMTU for a specified IPv6 address is set.

    By default, the PMTU is not set.

    If the parameter path-mtu is not specified, the PMTU for a specified IPv6 address is 1500 bytes.

Translation
Download
Updated: 2019-05-20

Document ID: EDOC1100034231

Views: 80243

Downloads: 51

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next