No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - IP Service

AR500, AR510, AR531, AR550, AR1500, and AR2500 V200R010

This document describes the concepts and configuration procedures of IP Service features on the device, and provides the configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Setting the Aging Time of Dynamic PMTU

Setting the Aging Time of Dynamic PMTU

Context

When the device functions as a source node and sends packets to a destination node, the device dynamically negotiates the PMTU with the destination node according to the IPv6 MTU values of interfaces and fragments packets based on the PMTU. After the PMTU ages out, the dynamic PMTU is deleted. The source node dynamically renegotiates the PMTU with the destination node.

NOTE:

When both static and dynamic PMTUs are configured, only static PMTU takes effect. Static PMTU entries never age.

The interface MTU, IPv6 interface MTU, and PMTU are valid only for packets generated on the device, not for packets forwarded by the host.

Procedure

  1. Run system-view

    The system view is displayed.

  2. (Optional) Configure the IPv6 MTU for an interface.

    1. Run interface interface-type interface-number

      The interface view is displayed.

    2. Run ipv6 mtu mtu

      The MTU of IPv6 packets on an interface is set.

      By default, the MTU of IPv6 packets on an interface is 1500 bytes.

      The dynamic PMTU is negotiated based on the IPv6 MTU on an interface.

      NOTE:
      • For the AR503GW-LM7, AR503GW-Lo, AR503GW-LcM7, AR503EDGW-Lc, AR503EDGW-Lo, AR503EW, AR503HGW-L, AR503HGW-Lc, AR509G-L-D-H, AR509G-Lc, and AR515GW-LM9-D, AR515CGW-L, the default value on the tunnel interface of the IPv6 over IPv4 tunnel is 1480 bytes.
      • After the MTU value is changed, run the shutdown and undo shutdown commands or the restart (interface view) command to restart the interface and allow the changes to take effect.

    3. Run quit

      The system view is displayed.

  3. Run ipv6 pathmtu age age-time

    The aging time is set for dynamic PMTU entries.

    By default, the aging time of dynamic PMTU entries is 10 minutes.

Translation
Download
Updated: 2019-05-20

Document ID: EDOC1100034231

Views: 83233

Downloads: 55

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next