No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - IP Service

AR500, AR510, AR531, AR550, AR1500, and AR2500 V200R010

This document describes the concepts and configuration procedures of IP Service features on the device, and provides the configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring ICMP properties

Configuring ICMP properties

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run icmp-reply fast

    The fast ICMP reply function is enabled.

    By default, the fast ICMP reply function is enabled on the device.

    NOTE:

    After the fast ICMP reply function is enabled on the device, the local policy-based routing function does not take effect for ICMP packets. Therefore, if the local policy-based routing function is configured on the device, you are advised to disable the fast ICMP reply function.

  3. Run icmp ttl-exceeded drop

    The device is configured to discard the ICMP packets whose TTL values are 1.

    By default, the function of discarding ICMP packets with TTL values 1 is disabled.

  4. Run icmp with-options drop

    The device is configured to discard the ICMP packets that carry options.

    By default, the function of discarding ICMP packets that carry options is disabled.

  5. Run icmp unreachable drop

    The function of discarding ICMP destination unreachable packets is enabled.

    By default, the function of discarding ICMP destination unreachable packets is disabled.

  6. Run icmp port-unreachable send

    The function of sending ICMP port unreachable packets is enabled.

    The function of sending ICMP port unreachable packets is disabled.

  7. Run icmp time-exceed { extension { compliant | non-compliant } | classic }

    The format of ICMP Time Exceeded packets is configured.

    By default, ICMP Time Exceeded packets carry extension headers in compliant mode and original datagrams are of variable length.

  8. Run icmp blackhole unreachable send

    The BRAS is disabled from sending a Destination Unreachable ICMP packet to an initiator when a tracert packet matches an IPv4 blackhole route.

    By default, the BRAS is disabled from sending a Destination Unreachable ICMP packet to an initiator when a tracert packet matches an IPv4 blackhole route.

  9. Run interface interface-type interface-number

    The interface view is displayed.

  10. Run

    undo icmp ttl-exceeded send

    The function to send ICMP Time Exceeded messages is enabled.

    By default, an interface is enabled to send ICMP Time Exceeded messages.

  11. Run icmp host-unreachable send

    The function of sending ICMP host unreachable packets is enabled.

    By default, the function of sending ICMP host unreachable packets is enabled.

Translation
Download
Updated: 2019-05-20

Document ID: EDOC1100034231

Views: 78598

Downloads: 51

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next