No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - IP Service

AR500, AR510, AR531, AR550, AR1500, and AR2500 V200R010

This document describes the concepts and configuration procedures of IP Service features on the device, and provides the configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring an IPv6 over IPv4 Tunnel

Configuring an IPv6 over IPv4 Tunnel

An IPv6 over IPv4 tunnel connects IPv6 networks through an IPv4 network.

Prerequisites

Source and destination devices of an IPv6 over IPv4 tunnel must have forwarding routes.

Pre-configuration Tasks

Before configuring an IPv6 over IPv4 tunnel, complete the following task:

Configuration Process

You can perform the following configuration tasks in any sequence according to usage scenarios shown in Table 11-1.

Table 11-1  Usage scenarios of IPv6 over IPv4 tunnels

Subcategory

Tunnel Source/Destination IP Address

Tunnel Interface IP Address

Usage Scenario

Manual IPv6 over IPv4 tunnel

Source and destination IP addresses use manually configured IPv4 addresses.

IPv6 address

Applies to simple IPv6 networks or point-to-point connections. Only IPv6 packets can be transmitted over the manual IPv6 over IPv4 tunnel.

IPv6 over IPv4 GRE tunnel

Source and destination IP addresses use manually configured IPv4 addresses.

IPv6 address

Applies to simple IPv6 networks or point-to-point connections. The IPv6 over IPv4 GRE tunnel supports multiple upper-layer protocols including IPv6.

Automatic IPv6 over IPv4 tunnel

The source IP address uses a manually configured IPv4 address, and the destination address is automatically generated.

IPv6 address that is compatible with an IPv4 address in the format of ::IPv4-source-address/96

Applies to point-to-multipoint connections of IPv6 hosts.

6to4 tunnel

The source IP address uses a manually configured IPv4 address, and the destination address is automatically generated.

6to4 address in the format of 2002:IPv4-source-address::/48

Applies to point-to-multipoint connections on IPv6 networks.

ISATAP tunnel

The source IP address uses a manually configured IPv4 address, and the destination address is automatically generated.

ISATAP address in the format of Prefix:0

Applies to connections of IPv6 nodes on an IPv4 network.

Translation
Download
Updated: 2019-05-20

Document ID: EDOC1100034231

Views: 80305

Downloads: 51

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next