No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - IP Service

AR500, AR510, AR531, AR550, AR1500, and AR2500 V200R010

This document describes the concepts and configuration procedures of IP Service features on the device, and provides the configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring a Tunnel Route

Configuring a Tunnel Route

Context

Packets can be forwarded correctly only when devices at the two ends of a tunnel are configured with forwarding routes. Perform the following configurations on devices at each end of the tunnel.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Use either of the following methods to configure routes passing through a tunnel interface.

    • Run ip route-static ip-address { mask | mask-length } tunnel interface-number

      A static route is configured.

      The static route must be configured on both ends of the tunnel. The destination address is the destination IPv4 address of the packets that are not encapsulated into IPv6 packets, and the next hop is the local tunnel interface.

    • Configure a dynamic route. Dynamic routes can be configured using IGP (excluding IS-IS) or BGP. The configuration method is not mentioned here.

      When configuring a dynamic routing protocol, enable the protocol on the tunnel interface and the interface on the link connecting the IPv4 network and IPv6 network.

Translation
Download
Updated: 2019-05-20

Document ID: EDOC1100034231

Views: 78616

Downloads: 51

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next