No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - Security

AR500, AR510, AR531, AR550, AR1500, and AR2500 V200R010

This document provides the basic concepts, configuration procedures, and configuration examples in different application scenarios of the network management feature supported by the device.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Example for Setting the Rate Limit in pps for Traffic Suppression

Example for Setting the Rate Limit in pps for Traffic Suppression

Networking Requirements

As shown in Figure 9-2, RouterA is connected to a Layer 2 network and a Layer 3 RouterB. To limit the number of broadcast, multicast, or unknown unicast packets forwarded on the Layer 2 network, you can set the rate limit in pps on Ethernet 2/0/0.

Figure 9-2  Network diagram of Setting the Rate Limit in pps for Traffic Suppression

Configuration Roadmap

The configuration roadmap is as follows:

  • Set the rate limit in pps for traffic suppression on Ethernet 2/0/0.

Procedure

  1. Enter the interface view.

    <Huawei> system-view
    [Huawei] sysname RouterA
    [RouterA] interface ethernet 2/0/0

  2. Set the rate limit in pps for broadcast packets.

    [RouterA-Ethernet2/0/0] broadcast-suppression packets 12600

  3. Set the rate limit in pps for multicast packets.

    [RouterA-Ethernet2/0/0] multicast-suppression packets 25200

  4. Set the rate limit in pps for unknown unicast packets.

    [RouterA-Ethernet2/0/0] unicast-suppression packets 12600
    [RouterA-Ethernet2/0/0] return

  5. Verify the configuration.

    Run the display flow-suppression interface command, and you can view the traffic suppression configuration on Ethernet 2/0/0.

    [RouterA] display flow-suppression interface Ethernet 2/0/0
     storm type         rate mode   set rate value                                  
    ------------------------------------------------------------------------------- 
     unknown-unicast    pps         pps: 12600(packet/s)                            
     multicast          pps         pps: 25200(packet/s)                            
     broadcast          pps         pps: 12600(packet/s)                            
    ------------------------------------------------------------------------------- 
    

Configuration Files

Configuration files on RouterA

#
 sysname RouterA 
#
interface Ethernet2/0/0
 unicast-suppression packets 12600
 multicast-suppression packets 25200
 broadcast-suppression packets 12600  
#
return
Translation
Download
Updated: 2019-05-20

Document ID: EDOC1100034236

Views: 95222

Downloads: 53

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next