No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


CLI-based Configuration Guide - Security

AR500, AR510, AR531, AR550, AR1500, and AR2500 V200R010

This document provides the basic concepts, configuration procedures, and configuration examples in different application scenarios of the network management feature supported by the device.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Storm Control

Storm Control

Figure 9-2  Networking diagram of storm control

As shown in Figure 9-2, RouterA is connected to a Layer 2 network and a Layer 3 RouterB. To limit the rates of broadcast packets, multicast packets, and unknown unicast packets forwarded by the Layer 2 network, configure storm control on the Layer 2 Ethernet interface Eth0/0/2 of RouterA.

Updated: 2019-08-09

Document ID: EDOC1100034236

Views: 111723

Downloads: 65

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next