No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade
FusionServer Pro E9000 Server iBMC (Earlier than V250) Alarm Handling 02
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
ALM-0341FFFF/0341FF17 PCIe Error (RAIDN PCIE ERR/NICN Status/MezzN Status)

ALM-0341FFFF/0341FF17 PCIe Error (RAIDN PCIE ERR/NICN Status/MezzN Status)

Description

Alarm message:

PCIe Error

This alarm is generated when the management software detects a critical alarm of a RAID controller card, LOM (LAN on Motherboard), or mezzanine card.

This alarm is generated by the following sensors:

  • RAIDN PCIE ERR (N indicates a RAID card slot number.)
  • NICN Status (N indicates a LOM slot number.)
  • MezzN Status (N indicates a mezzanine card slot number.)

If the server supports only one RAID controller card or mezzanine card, the corresponding sensor names do not include N.

Attribute

Alarm ID

Alarm Severity

Auto Clear

iBMC: 0341FFFF

MM: 0341FF17

Critical

Yes

Parameters

Name

Meaning

Time

Time when an alarm is generated.

Sensor

Name of the sensor that generates an alarm.

Event

Details about an alarm.

Severity

Severity of an alarm.

Event Code

Event code of an alarm.

Impact on the System

The system may restart or stop responding.

Possible Causes

The PCIe device is faulty.

Procedure

  1. Gracefully power off the server and check whether the PCIe device or slot is faulty or poorly connected.

  2. Power on the server to start the power-on self-test (POST) and then run test software. Check whether the POST succeeds and the test software finds no fault.

  3. Check whether the alarm is cleared.

    • If yes, no further action is required.
    • If no, go to Step 4.

  4. Replace the part that may be faulty. Then check whether the alarm is cleared.

    • If yes, no further action is required.
    • If no, go to Step 5.

  5. Contact Huawei technical support for help.
Translation
Download
Updated: 2019-11-19

Document ID: EDOC1100035007

Views: 32409

Downloads: 12

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Share
Previous Next