No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

E9000 Server Compute Node and Switch Module iMana 200 Alarm Handling 01

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
ALM-0x2100FFFF EEPROM Self-Check Failed Major Alarm (EEPROM Status)

ALM-0x2100FFFF EEPROM Self-Check Failed Major Alarm (EEPROM Status)

Description

Alarm message:

Fault status

This alarm is generated when the iMana 200 EEPROM self-check failed.

This alarm is generated by the following sensor: EEPROM Status

Attribute

Alarm ID

Alarm Severity

Auto Clear

0x2100FFFF

Major

Yes

Impact on the System

The iMana 200 cannot read or write the mainboard electronic label (E-Label) information.

Possible Causes

  • The iMana 200 does not work normally.
  • The mainboard is faulty.

Procedure

  1. Restart the iMana 200. Then check whether the alarm is cleared.

    • If yes, no further action is required.
    • If yes, go to 2.
    You can restart the iMana 200 using either of the following methods:
    • On the HMM CLI, run the telnet 0 1101 command, switch to the iMana 200 CLI, and run the ipmcset -d reset command.
    • On the HMM WebUI, choose Chassis settings > Network Settings > Node, switch to the iMana 200 WebUI, choose System > Firmware Upgrade, and click Restart iMana 200

  2. Reseat the compute node and then check whether the alarm is cleared.

    • If yes, no further action is required.
    • If yes, go to 3.

  3. Replace the mainboard and then check whether the alarm is cleared.

    • If yes, no further action is required.
    • If yes, go to 4.

  4. On the HMM WebUI, choose System Management > Information Collection, and collect logs.
  5. Contact Huawei technical support.
Translation
Download
Updated: 2018-08-16

Document ID: EDOC1100035007

Views: 15493

Downloads: 8

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next