No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Typical Configuration Examples

SD-WAN V100R018C00

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Communication Between SD-WAN Sites and Legacy Sites in Centralized Access Mode

Configuring Communication Between SD-WAN Sites and Legacy Sites in Centralized Access Mode

Related Products

Agile Controller-Campus: V300R003C00

AR: V300R003C00

Networking Requirements

Figure 1-22 shows the SD-WAN networking of Enterprise A. On this network, Site1 is a legacy site outside an SD-WAN network. The enterprise requires that all SD-WAN sites communicate with Site1.

Figure 1-22 Enterprise networking

Solution Design

The tenant administrator has completed SD-WAN network configurations. The active and standby hub site are each connected to the MPLS network through an MPLS link, and Site1 is also connected to the MPLS network. The centralized access mode can be configured to enable branch sites to communicate with Site1 through the hub sites.

Data Plan

Table 1-66 Site-to-legacy site policy information

Item

Value

Centralized access

Hub1, Hub2

Link Priority

WAN links at Hub1

MPLS1

3

WAN links at Hub2

MPLS1

3

Procedure

  1. Log in to the Agile Controller-Campus as a tenant administrator.
  2. Finish creating sites.
  3. Configure a site-to-legacy site policy at hub sites on the overlay network to enable communication between SD-WAN sites and the legacy site.

    1. Choose Configuration > Traffic Policy.
    2. Click Site-to-Legacy Site. On the Site-to-Legacy Site tab page, click Centralized access to configure the access mode.
    3. Click Create, select hub sites and click IGW to enable the gateway function for communication between SD-WAN sites and legacy sites.

    4. Click in the Operation column to activate the egress link. Configure the link priority and click Apply Changes on the main page.

Translation
Download
Updated: 2019-03-04

Document ID: EDOC1100036696

Views: 18021

Downloads: 116

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next