No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Typical Configuration Examples

SD-WAN V100R018C00

Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring WAN-side Static Routes

Configuring WAN-side Static Routes

Related Products

Agile Controller-Campus: V300R003C00

AR: V300R003C00

Networking Requirements

Figure 1-17 shows the SD-WAN networking of an enterprise. On the SD-WAN network constructed by the tenant administrator, the LAN-side networks of each site belong to different network segments. The enterprise requires that devices in LAN-side networks communicate with one another.

Figure 1-17 Enterprise networking

Solution Design

Based on customer requirements and the networking plan, the tenant administrator has created the hub sites and branch sites, and configured LAN-side interfaces on the overlay network. To configure WAN-side routes on the overlay network, perform the following tasks:

  1. At Hub1, configure a WAN-side static route whose next hop points to Branch2.
  2. At Hub2, configure a WAN-side static route whose next hop points to Branch2.
  3. At Branch2, configure a WAN-side static route whose next hop points to Hub1.

Data Plan

Table 1-59 WAN-side static route information

Item

Value

Site

Hub1

Hub2

Branch2

Logical Link(s)

Standby logical link(s)

Standby logical link(s)

Standby logical link(s)

Priority

220

220

220

Destination address/mask

10.4.1.0/24

10.5.1.0/24

10.4.1.0/24

10.5.1.0/24

0.0.0.0/0

Next-hop type

Site

Site

Site

Site

Branch2

Branch2

Hub1, Hub2

Procedure

  1. Log in to the Agile Controller-Campus as a tenant administrator.
  2. Finish creating sites.
  3. Configure LAN-side interfaces on the overlay network of sites.
  4. Configure WAN-side static routes of Hub1.

    1. Choose Configuration > Overlay Network > Site Configuration.
    2. Select Hub1 from the list on the left, click WAN Route tab in the right pane, and select Static.
    3. On the Static page, click Create to configure static routes, and click Apply Changes on the main page.

    4. After the configuration is complete, the configured static routes are displayed in the list.

  5. Configure WAN-side static routes of Hub2. The operations are the same as those in Step 4.
  6. Configure WAN-side static routes of Branch2.

    1. Choose Configuration > Overlay Network > Site Configuration.
    2. Select Branch2 from the list on the left, click WAN Route tab in the right pane, and select Static.
    3. On the Static page, click Create to configure static routes, and click Apply Changes on the main page.

    4. After the configuration is complete, the configured static routes are displayed in the list.

Translation
Download
Updated: 2019-03-04

Document ID: EDOC1100036696

Views: 17824

Downloads: 116

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next