No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Typical Configuration Examples

SD-WAN V100R018C00

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring LAN-side OSPF Routes

Configuring LAN-side OSPF Routes

Related Products

Agile Controller-Campus: V300R003C00

AR: V300R003C00

Networking Requirements

Figure 1-15 shows the SD-WAN networking of an enterprise. On the SD-WAN network constructed by the tenant administrator, two gateways at the hub site are connected to hosts through the same Layer 3 switch. The gateways and Layer 3 switch are in the same VLAN and therefore belong to the same network segment. The enterprise requires that the gateways at the hub site communicate with the Layer 3 switch.

Figure 1-15 Enterprise networking

Solution Design

Based on customer requirements and the networking plan, the tenant administrator has created the hub site and branch sites, and configured LAN-side interfaces on the overlay network. To configure OSPF routes on the LAN side for interconnection between LAN-side networks, perform the following tasks:

  1. Configure two gateways to run the same OSPF process.
  2. Enable OSPF on LAN-side interfaces.

Data Plan

Table 1-56 LAN-side OSPF route information

Item

Value

Device

Hub1_1

Hub1_2

Process ID

1001

1001

Common Parameter

Default route advertisement

ON

ON

Default route cost

1

1

Internal preference

10

10

ASE preference

150

150

Interface Parameter

Area ID

0

0

Interface Name

Vlanif10

Vlanif10

Authentication Mode

None

None

Hello Timer

10

10

DR Priority

0

0

Route Redistribute

Protocol

-

-

Process ID

-

-

Cost

-

-

Router Filter

Export filter

OFF

OFF

Import filter

OFF

OFF

Procedure

  1. Log in to the Agile Controller-Campus as a tenant administrator.
  2. Finish creating sites.
  3. Configure LAN-side interfaces on the overlay network of sites.
  4. Configure OSPF routes on the LAN side of Hub1.

    1. Choose Configuration > Overlay Network > Site Configuration.
    2. Select Hub1 from the list on the left and click the LAN Route tab in the right pane.
    3. Click Click Here to Add Routing Protocol or ,and select OSPF.
    4. On the OSPF page, click Create to configure OSPF routes and click Apply Changes on the main page.
    • OSPF configurations for Hub1_1

    • OSPF configurations for Hub1_2

Translation
Download
Updated: 2019-03-04

Document ID: EDOC1100036696

Views: 18029

Downloads: 116

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next