No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

FusionServer Pro XH628 V5 Server Node V100R005 Maintenance and Service Guide 03

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Installing a Memory Module

Installing a Memory Module

Procedure

  1. Power off the server node.

    For details, see Power-Off Procedure.

  2. Remove the server node.

    For details, see Removing an XH628 V5.

  3. Place the server node on the ESD workstation.
  4. Remove the drive drawer.

    For details, see Removing the Drive Drawer.

  5. Lift the memory air ducts.

    Figure 4-34 Removing memory air ducts

  6. Take a spare memory module.
  7. Check the positions and installation guidelines of the memory modules.

    For details, see Memory Installation Positions.

    Figure 4-35 Memory slots

  8. Install the memory module.

    1. Open the two memory module ejectors on the memory slot.
      Figure 4-36 Opening the memory module ejectors
    2. Align the edge connector of the memory module with the alignment key of the memory slot, and insert the memory module in the slot.

      The two memory ejectors are closed automatically after the memory module is firmly seated.

      NOTE:

      Do not touch the edge connector on a memory module with bare hands. Before installing a memory module, ensure that the edge connector is not contaminated.

      Figure 4-37 Installing a memory module

  9. Aligning the edges of the memory air duct with the memory modules, vertically place the air duct downwards.

    Figure 4-38 Installing memory air ducts

  10. Install the drive drawer.

    For details, see Installing the Drive Drawer.

  11. Install the server node.

    For details, see Installing an XH628 V5.

  12. Power on the server node.

    For details, see Power-On Procedure.

  13. Check whether the memory module is replaced successfully.

    1. Log in to the iBMC WebUI.

      For details, see Logging In to the iBMC WebUI.

    2. Choose Information > System Info > Memory, and check the memory information.

Translation
Download
Updated: 2019-08-12

Document ID: EDOC1100036739

Views: 15634

Downloads: 20

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next